Default Processing Profiles - how to use?

Software RawTherapee
, ,
21

Well, actually I checked again and somehow those two paths got reverted to (None), probably me testing around being the case. I changed it back to “Settings/profiles” and voila… it works.

But this introduces a new problem. As I have to use “(Dynamic)” for “Default Processing Profile” in “Preferences->Image Processing” all photos that I don’t make a Dynamic Profile Rule for will not be applied with “Auto-Matched Curve - ISO Low” as I normally have adjusted.

The software rather should have a setting where I can adjust which Default Processing Profile should be used for images that don’t have a relevant Dynamic Profile Rule.

22

Perhaps one setting with camera and no lens and one with camera with this lens? Don’t know if it works - just guessing.:wink:

23

That would work. That is what I use, Two cameras and 5 lenses. Plus iso-specific settings. In total about 25 profiles which are dynamically merged. All these profiles are defined as partial profiles.

24

Right. I will check what suits me best.