I’m using 1.4.0b4, I’m enthusiast of this piece of sw!
But I’ve a problem when I’m preprocessing a deepsky sequence: after Conversion and Calibration, I do Registration with Global Star Alignment method (single pass). If I’ve e.g. 22 frames, after the registration I end with only 21 frames, 1 is missing! I tested many sequences (with 4 up to 45 frames) and it seems to me a bug.
I’ve found a workaround, check 2ndpass, register with Global Star Alignment method, then register again with method Apply Existing Registration, so this keeps all 22 frames. But it is quite annoying to do so.
Can you check?
Regards,
Lorenzo
Will be fixed in next release, see here: Reference image no longer in frame list after registration - #2 by cissou8
2 Likes
In my experience, the registered reference frame is created but not included in the registered frames sequence. You may go to Convert tab and load every registered frame (i.e. included the missing one) and create a new sequence.
Workaround is to use 2-pass registration. See manual.