Siril registration global star alignment by command line doens't find star 1.2.1

Software Siril
1

I calibrated and register my light using command line by pysirl.
If I use interface and Global Star Alignment it works, but if I register by command line it doens’t find enough stars.
I use the command:

preprocess light
register pp_light

in the reference I don’t find any way to use Global Star Alignment. I suppose I have to use PSF Dynamic or Findstar, but I’m not sure about it.

From interface I have the log:

12:52:02: Registration: processing using method: Global Star Alignment (deep-sky)
12:52:02: Interpolation clamping active
12:52:02: Global star registration: with the current memory and thread limits, up to 2 thread(s) can be used
12:52:02: Recomputing already existing registration for this layer
12:52:02: Reading FITS: file r_seq_00002.fit, 1 layer(s), 2056x2062 pixels, 16 bits

Could you help me?

2

Hello.

register is the global star alignment

If it does not find enough star, yes, you must adjust settings with setfindstar if you do use command line.

3

Good news, but I’m still confused: in the interface I don’t set any value and I see the value

image
image701×657 116 KB

I have to set it with setfindstar?

4

Are you sure to do it on the same image?

5

I found the problem, from command line I made the calibration instead from interface i just registered the files. Thank you for you support, your questions help me a lot :slight_smile: