I have had similar crashes but without the Panasonic. In the end it turned out that it was my fault.
Closing ART and deleting ~/.cache/ART, then restarting ART solved my problems. Something went wrong in the cache and now everything works âhonky-doryâ.
Thereâs another notable difference between art-rawconverter and art-rawconverter-bin: art-rawconverter will use the libs shipped with your distribution (e.g. Arch or Manjaro), while art-rawconverter-bin brings all required libs with versions defined by Alberto.
This especially means that art-rawconverter will not make use of libraw unless you manually switch to libraw-git as ART requires libraw 0.21 which has not been released yet. In this case ART will use the vendored dcraw.c which might result in strange behaviour - ART is going to switch to libraw for a reason.
Unfortunately, I understand too little of the details mentioned. But may I conclude that it is better to install the -bin version? Is this generally true in the AUR?
Yes, thatâs what I mean: everything becomes very slow, I canât select any new places with the picker for a few seconds, but the mouse can still be moved and at the bottom you can see âProcessing imageâ with the yellowish bar, which sometimes stands still, sometimes moves to the right. And when it arrives to the right, ART rages normally again.
Now I switched off the noise reduction: Now the delay is only half a sec., if Sharpening, Noise reduction, Impulse noise reduction and Defringe are switched on, the delay is quite 8 sec. or more.
@agriggio I donât think you need to change anything, this behavior is normal.
I am very happy that ART with the -bin version is stable after all.
Thank you all very much.
As the -bin version seems to fix the issues for you, in your case it is better to use the -bin version. This might not be the case for other people - generally speaking there is no âbetterâ in such cases, itâs just different with different pros and cons.
Hallo @guzzisti
Thatâs great.
Do you mean that now all ART in AUR are all up-to-date? Should I then install the normal one, or is the -bin still the right one for Manjaro?
yes, something has changed. ART (1.16.4 form -bin) no longer tends to freeze when I use the WB picker often and quickly. Only a short delay of barely one second. The updates have somewhat turned that off.
Es ist einfach gar nicht mehr möglich, den WB mehrfach unmittelbar hintereinander anzuwenden, da direkt nach dem ersten Mal das Werkzeug abgewĂ€hlt wird. Das ist genau die Ănderung, die Alberto angekĂŒndigt hat. Wenn du trotzdem Schabernack damit machen willst, drĂŒck ganz schnell mehrfach Shift+W, Linksklick hintereinander.
ART has now become very stable.
So the problem has long since been solved - does anyone know how I can mark this, e.g. with [solved]? Unfortunately, I can no longer change the title.